Disclosure: As an Amazon Associate we earn from qualifying purchases. We may earn a commission if you buy through our links, at no extra cost to you.
The short answer: To wear a FlipBelt Classic, place it around your waist with the pockets facing toward your body, slide it up to your hips (just above your pants or shorts), and position it so that the larger pocket is at your lower back. Pull the belt up so it sits snugly but comfortably, and use the internal key loop to secure your essentials. That’s it, you’re ready to run without the bounce.
Before you even put it on, make sure your FlipBelt Classic is the correct size. FlipBelt sizes run from XS to XL, and their size chart is based on your hip measurement (the widest part of your hips). A good rule of thumb: if you’re between sizes, size up. If the belt is too tight, it will ride up and cause chafing; too loose, and it will bounce around. The belt should sit snugly on your hips, but you should be able to slide two fingers underneath it comfortably.
Step 1: Orient the belt correctly. The FlipBelt Classic has five pockets: one large one that spans the width of the belt (usually at the back), and four smaller ones in the front. The large back pocket is for your phone. The smaller front pockets are for keys, cards, or gels. The belt is reversible, but the standard orientation has the pockets facing your body. If you prefer the pockets facing outward, you can flip it, but for security, most people keep the pockets inward.
Step 2: Slip it on. Step into the belt like you would a skirt, or pull it up over your feet and legs. If you’re wearing it over pants, that’s fine, but for maximum comfort and to avoid any sliding, wear it directly on your skin under your shirt or over a thin layer like a t-shirt.
Step 3: Position it at your waist. Pull the belt up so it sits on your hips, not your natural waist. Your hips are the bony part that sticks out slightly, usually a few inches below your belly button. The belt should rest there, not on your waist (the narrow part above your hips). If it sits too high, it will ride up when you run.
Step 4: Adjust the belt’s rotation. Once the belt is on, rotate it so that the large back pocket is centered on your lower back. The smaller pockets should be spread across your front and sides. Make sure the belt is not twisted. You can check by feeling the seams: there should be a smooth top and bottom edge. If you feel a twist, adjust.
Step 5: Load your gear. Place your phone in the large back pocket, screen facing inward. Keys go in the small front pockets, using the internal key loop to secure them (push the key through the loop, then flip the key over and press it closed). Cards or cash can go in the other small pockets. If you have gels, they can fit in the outer smaller pockets as well.
Step 6: Adjust the fit tightness. If the belt feels too loose, you can tighten it by pulling the belt up higher on your hips, but if it’s already at your hips and still loose, you may need a smaller size. If it’s too tight and causing discomfort, consider sizing down, but remember it should be snug.
Most people wear the FlipBelt Classic under their shirt to keep it concealed and to prevent it from sliding against clothing. Wearing it directly on your skin also helps keep it in place, especially if you sweat. However, if you’re wearing it for a race and need quick access to your phone or gels, you might prefer to wear it over your shirt. That works too, but be aware that it might bounce more if your shirt is silky. For winter running, you can wear it over a base layer but under a jacket.
Wearing it too high. If you wear the belt on your waist, it will ride up and you’ll constantly be pulling it down. Your hips are the natural hold for this belt.
Overloading the front pockets. The front pockets are smaller and designed for flat items. If you stuff them with bulky objects, they’ll dig into your stomach and cause discomfort.
Not securing the key loop. The internal key loop is there for a reason. If you toss your keys in without securing them, they’ll slide around and can pop out.
Forgetting to rotate the belt. If you put it on and run with the large pocket on your side, it will feel bulky and unbalanced. Take a second to center it on your lower back.
FlipBelt Classic is machine washable. To keep it in top shape, wash it on a gentle cycle with cold water and hang it to dry. Do not put it in the dryer, as the heat can damage the elastic. Also, avoid using fabric softeners, which can break down the elastic over time. With proper care, your belt will last for years.
Q: Can I wear the FlipBelt Classic while swimming? A: The FlipBelt is not designed for swimming; it’s a running belt. It will absorb water and become heavy, and the fabric may retain water.
Q: Does the FlipBelt Classic fit a large phone? A: It depends on the size. The large back pocket can fit most phones up to about 6.5 inches, but if you have a massive phone like the Pro Max series, it might be a tight squeeze. Check the dimensions of your phone against the belt’s pocket size. If it doesn’t fit, consider the FlipBelt 2.0, which has a larger phone pocket.
Q: How do I know which size to order? A: Measure your hips at the widest point (around the buttocks) and compare it to the FlipBelt size chart. If you’re between sizes, size up for comfort. If you’re using it for running and want a secure fit, sizing down might be fine if you prefer a tighter hold, but remember you’ll be wearing it over clothing sometimes.
If you’re not sure if the FlipBelt Classic is the right belt for you, or if you want to compare it with other popular options, check out our comprehensive best running belts guide to find the perfect one for your needs.
We don't accept free units or payment for placement. Our rankings combine verified manufacturer specifications, real owner feedback and availability, compared on one transparent S to C rubric.
Honesty note: We have not hands-on tested every product mentioned on this page. Where we have not personally used a product, any ranking referenced here is based on verified specs, aggregated owner feedback, availability and editorial comparison rather than a hands-on review.